3 Series E36 320i (M50) COUPE
Unscrew and remove oil pump.
Installation:
Note dowel sleeves.
Pull out oil pan towards rear.
Installation:
Sealing faces clean and free of seal debris.
Coat contact edges along joint with Drei Bond 1209 (refer to
BMW Parts Service).
Check seal, replace if necessary.
Insert all screws in oil pan.
Insert but do not yet tighten oil pan screws, on transmission
end.
Tighten down screws on engine end.
Tighten screws on transmission end.
RA Removing and installing, sealing or replacing oil pan ( M50 to 9 / 92 )
BMW AG - TIS
06.02.2013 22:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
