3 Series E36 325tds (M51) TOUR
Define, mark out and cut connection point between outer D-pillar /
gutter.
Dimension (A) = 15 mm from edge of recess for cable guide to
tailgate/trunk lid.
Drill out welding points on inner connection point of D-pillar and
inside section of roof frame.
Drill out welding points between connection point of inner D-pillar /
tail panel.
Open up connection point between lamp support / tail panel.
Remove D-pillar.
Remove scrap metal. Straighten and grind joint surfaces.
RA Replacing rear roof pillar (side panel removed) (touring)
BMW AG - TIS
09.02.2013 02:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
