3 Series E36 M3 (S50) CONVER
Inspection of throttle valve kinematics:
Trap paper strip between 3 detent screws and the kinematic
detents. Pull on paper. If the paper can be pulled out slightly, carry
out throttle body basic setting.
Connect DIS after completing base setting. Select Check and
adjust exhaust content and carry out exhaust synchronization.
Proceed following instructions given by DIS.
Release screws in exhaust manifold.
Caution!
The screws are very hot.
Release screws in exhaust manifold.
Caution!
The screws are very hot.
RA Basic throttle setting/exhaust synchronization (S50 B32)
BMW AG - TIS
09.02.2013 21:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -