3 Series E36 M3 (S50) SAL
Pull off VANOS control unit.
Note:
Splined shaft remains in VANOS unit on engine.
Installation
Installation of VANOS adjustment unit is described separately
from removal. Assembly sequence differs between removal and
installation.
Replace O-rings on VANOS adjustment unit and splined shaft.
Fit driver of radial piston pump to drive shaft using grease as an
aid.
Align radial piston pump on driver.
Slide on VANOS adjustment unit until sealing rings are still just
accessible.
Clean and degrease sealing faces between end cover (VANOS
bridge) and timing case.
Apply thin and uniform coat of Drei Bond 1209 sealing
compound, refer to BMW Parts Service.
Pay attention to dowel pins (1).
RA Removing and installing, sealing/replacing VANOS adjustment unit (S50 B30)
BMW AG - TIS
09.02.2013 21:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
