3 Series E36 M3 (S50) SAL
Installation:
Center bearing must be aligned at right angles to propeller
shaft.
Pretension center bearing in direction of travel (A = 2 ... 4
mm)
Tightening Torque,
refer to Technical Data 26 11 6AZ.
Caution!
Do not let propeller shaft fall into joints. In particular, on the
constant velocity joint, the rubber sleeve gets squashed or the
joint is damaged.
Bend propeller shaft downwards on center bearing. Remove
propeller shaft from transmission output flange. Using a piece of
cord or wire, secure to side on underbody.
Release nuts, remove clutch slave cylinder. Pressure line remains
connected.
Caution!
Relieve tension on clutch slave cylinder slowly; otherwise air
will be drawn in through sealing sleeve.
Installation:
Tightening Torque,
refer to Technical Data 21 52 5AZ.
RA Removing and installing transmission (S6S 420G SMG)
BMW AG - TIS
09.02.2013 23:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
