3 Series E36 M3 (S50) SAL
Attach special tool 11 8 022 to left and right control arms.
Caution!
Locate special tool in such a position that engine oil pan rests
securely on special tool.
Tighten down knurled screws until special tool makes contact with
engine oil pan.
Secure special tool 11 8 021 to front axle support.
Turn screw (1) upwards until it is flush with the oil pan.
Note:
This support prevents the engine from tilting forwards while
the transmission is being removed.
Unfasten screws.
Caution!
Do not allow transmission to hang on transmission input shaft
when removing and installing, as the clutch disc will be
deformed.
Pull transmission downwards and remove.
Installation:
Always fit screws (1) with narrow collar using shims.
Fit screws (2) with wide collar without any shims.
Tightening Torque,
refer to Technical Data 23 00 1AZ.
RA Removing and installing transmission (S6S 420G SMG)
BMW AG - TIS
09.02.2013 23:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -
