3 Series E46 316i (N42) SAL
If necessary, replace plain compression rings (1).
Important!
Plain compression rings (1) can easily break.
Plain compression rings (1) are engaged at joint.
Press compression ring (1) on one side into groove, pull up on
other side and unhook catch.
Carefully pull compression ring (1) apart and remove towards
front.
Clean all bearings and cams of inlet camshaft and lubricate with
engine oil.
Installation:
Installing compression rings (1):
Important!
Plain compression rings (1) can easily break.
Carefully pull compression ring (1) apart and install from front.
Press compression ring (1) on one side into groove, hook in
catch on other side.
Insert inlet camshaft (1) so that curvature on twin surface points
downwards.
Ends of compression rings (1) point upwards.
Make sure compression rings (1) are engaged at ends.
RA Removing and installing/replacing inlet camshaft (N42/N46)
BMW AG - TIS
20.01.2013 18:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -
