3 Series E46 318ti (N42) COMP
Lever out wheel arch trim (1) on left/right, pulling bumper (2)
forward slightly in so doing.
Firmly pull off bumper on both sides towards front. In so doing,
grip primarily edge of wheel arch (1) (do not pull at sides).
Caution!
Do not pull bumper too far; there is a risk of damage to the
electrical fittings (connecting cable, air horn, fog lamps).
Installation:
Retaining lugs (1) must not be damaged.
Disconnect plug connections (1) of air horn on left/right.
Version with fog lamps:
Also disconnect plug connections (2) of fog lamps on left/right.
Remove bumper (3) towards front.
RA Removing and installing complete front bumper (compact)
BMW AG - TIS
12.02.2013 08:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -