3 Series E46 320d (M47) SAL
11 44 000
Removing and installing/sealing or replacing
oil-water heat exchanger (M47)
Caution!
When working on the oil, coolant or fuel circuit, you must
protect the alternator against contamination.
Cover alternator with suitable materials.
Failure to comply with this procedure may result in an alternator
malfunction.
Note:
Switch off ignition.
Follow instructions for disconnecting and connecting battery.
Disconnect and cover battery negative lead.
Follow instructions for working on cooling system.
Unscrew and remove splash guard.
Drain off and top up coolant.
Vent cooling system and check for leaks.
Caution!
Do not damage main flow oil filter cover; release and tighten
down with socket only.
When the main flow oil filter cover is released, the oil flows
from the oil-water heat exchanger back into the sump.
Release main flow oil filter cover and take off.
RA Removing and installing/sealing or replacing oil-water heat exchanger (M47)
BMW AG - TIS
12.02.2013 13:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
