3 Series E46 320d (M47) TOUR
Remove main flow oil filter cover, remove oil filter element and
drain off engine oil.
Remove engine underguard.
Drain and dispose of coolant,
refer to General Information for working on cooling system.
Installation:
Replace seal.
Tightening torque, 11 11 5AZ.
Cooling system must be topped up, vented and checked for leaks.
Release hose clamps (1 and 2) and detach water hoses from
oil-water heat exchanger.
Assemble special tool 00 0 200 with special tool 00 0 201 /
00 0 202 / 00 0 204 / 00 0 208 and install.
Secure special tool 00 0 200 to front engine suspension eye.
Note:
The supports (1) of special tool 00 0 208 must rest on the bolt
connection of both side walls.
RA Removing and installing/sealing or replacing complete main flow oil filter (M47)
BMW AG - TIS
12.02.2013 13:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -