3 Series E46 320d (M47) TOUR
Lay special tool 11 2 300 (plug mandrel) parallel to speed
sensor (1) on reinforcing rib of engine, force it approx. 1...2 cm
into support in crankcase and grip firmly.
Rotate crankshaft in direction of engine rotation until special tool
11 2 300 (plug mandrel) audibly snaps into place.
Note:
Cast lug (1) on inlet camshaft points upwards at firing TDC,
cylinder 1.
Read dial gauge.
Evaluation of measurement:
The value read off may deviate from the value stamped on the
injection pump by max.
±
0.1 mm.
If deviations are greater than
±
0.1 mm, statically adjust
injection pump,
refer to 13 51 005.
Remove special tool 13 5 200 together with special tool
00 2 510 (dial gauge).
RA Removing and installing/replacing injection pump (M47)
BMW AG - TIS
12.02.2013 13:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 12 -