3 Series E46 330d (M57) TOUR
Install nut, grip cable pulley and tighten nut to specified torque.
Tightening torque,
refer to Technical Data 12 72 1AZ.
Adjustment dimension, RHD vehicle:
Observe installation dimension A of cable pulley (1) on pedal
travel sensor (2):
1.
Cable pulley
2.
Pedal travel sensor
3.
Wiring outlet
Caution!
Observe position of wiring outlet (3) when adjusting.
Measurement A: 75
°
Install nut, grip cable pulley and tighten nut to specified torque.
Tightening torque,
refer to Technical Data 12 72 1AZ.
Perform function check:
Check idling and full-throttle positions with DIS Tester or MoDiC.
If the idle speed value is not achieved, the cable pulley of the
pedal travel must be readjusted.
If the idle speed value is reached but not the full load value, the
mechanical full load stop on the accelerator pedal must be
corrected.
RA Removing and installing / replacing pedal travel sensor (M47 / M57)
BMW AG - TIS
15.02.2013 12:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
