3 Series E46 330xd (M57) TOUR
Install bracket/rubber mount up to measurement (A).
Load must be removed from rubber mount during measurement -
slacken special tool.
A = 170
±
1 mm below at control arm from rubber mount to edge
of bore in control arm.
Caution!
Bolt bracket and control arm to front axle support immediately.
Leave car for min. 30 minutes in empty weight position and
avoid major spring deflections.
After approx. 30 minutes, the antiseize agent is fully
evaporated and the control arm is firmly seated and correctly
positioned in the rubber mount.
Non-conformance with these procedures could lead to serious
impairment of handling!
RA Replacing bracket for left or right control arm (4WD)
BMW AG - TIS
16.02.2013 00:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
