3 Series E46 M3 CSL (S54) COUPE
51 71 374
Removing and installing / replacing
reinforcement plate on front axle support (M3)
Special tools required:
•
00 9 120
Caution!
Vehicles must not be driven without reinforcement plates.
Driving without the reinforcement plate may damage the front
axle.
Screws of reinforcement plate must be tightened to torque
and then tightened down with special tool 00 9 120 (angle-
of-rotation measuring disk).
Release screws (1).
Release screws (2) and remove reinforcement plate (3).
Installation:
Replace screws (2).
-
Install all screws
-
Tighten screws (2) to torque and then to angle of rotation,
tightening torque, 51 71 3AZ.
-
Tighten down screws (1).
RA Removing and installing / replacing reinforcement plate on front axle support (M
BMW AG - TIS
17.02.2013 00:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -