3 Series E46 M3 (S54) CONVER
Pull shift rod (1) out of shift rod joint (2).
Remove washers (3).
Installation:
Grease shift rod pin (4).
Grease,
refer to BMW Service Operating Fluids.
Large contact surface of disks (3) must rest on shift rod joint
(2).
Lever out spring (1) with a screwdriver from lug (2) on housing.
Tilt spring upwards.
Remove bearing pin (1).
Installation:
Grease bearing pins (1).
Grease,
refer to BMW Service Operating Fluids.
Release screws.
Tightening torque, 23 00 1AZ.
Caution!
Do not allow the transmission to hang off from the
transmission input shaft as this will deform the clutch disk.
Pull out transmission towards rear as far as possible, turn approx.
10
°
counterclockwise and remove.
RA Removing and installing transmission (S6S 420G)
BMW AG - TIS
16.02.2013 11:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -