3 Series E90 335xi (N54) SAL
12 14 651
Replacing suction pressure sensor on
charge-air duct (N54)
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Switch off ignition
Note:
The installation location of the suction pressure sensor is at the
rear end of the charge-air duct.
Preparatory tasks:
•
Remove suction filter housing.
Unlock plug (1) and remove.
Release screws and pull suction pressure sensor (2) out of
charge-air duct.
Tightening torque 13 62 2AZ
.
Installation:
Check sealing ring for damage, replace if necessary.
When installing, coat sealing ring with suitable antiseize agent.
Note:
Check stored fault messages.
Now clear the fault memory.
RA Replacing suction pressure sensor on charge-air duct (N54)
BMW AG - TIS
22.02.2013 10:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -