3 Series E90 M3 (S65) SAL
26 11 000
Removing and installing complete propeller
shaft (constant-velocity joint)
Necessary preliminary tasks:
-
Remove rear underbody protection
-
Remove complete exhaust system
-
Remove heat shields
Release screws.
Installation:
ZNS bolts and nuts must be replaced.
Replace self-locking nuts.
Tightening torque, 26 11 1AZ .
Release bolts and replace.
Using a screwdriver, press constant velocity joint off drive flange
at disassembly grooves.
RA Removing and installing complete propeller shaft (constant-velocity joint)
BMW AG - TIS
22.02.2013 12:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
