5 Series E34 525td (M51) TOUR
Notes:
Before the action described in this Service Information bulletin is implemented, always
perform the following checks first:
-
With complaints regarding shift comfort and emergency program:
Interrogate error memory in EGS and DME/DDE and print out.
Ensure that battery voltage is > 9.4 volts at time of reading.
-
In addition to problems in conjunction with gear engagement or manual shifts using
selector lever:
Check the gearshift cable adjustment (refer to Repair Instructions) and idle speed.
Establish control unit adaptation level on vehicle
-
Interrogate DME hardware number and EGS data status/software number with DIS
BMW Service Tester or MoDiC.
-
DME hardware number and EGS data status/software number are located on DME
and EGS identification page presented when you enter the relevant diagnosis system.
Replace hydraulic shift unit
-
Before installing the hydraulic shift unit, first check whether the shift unit centring pin
has been fitted to the transmission housing.
Refer to Enclosure 9
Parts:
The required parts are available through the usual parts distribution channels. Refer to the
relevant Enclosure (1 - 6) for details of the part designations and part numbers.
SI Transmission problems reported A5S 310Z (5HP18)
BMW AG - TIS
23.01.2013 05:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -