5 Series E39 M5 (S62) SAL
Cylinder bank 5 to 8:
Note:
To tighten down screws on VANOS gear: Use special tool
11 7 200 .
Tighten down six accessible screws (three on exhaust side and
three on inlet side) on VANOS gear to 10 Nm.
Then slacken all six screws again by a 1/4 turn.
Cylinder bank 5 to 8:
Install all bolts. Alternately tighten down bolts in 1/2 turn
increments carefully and evenly until VANOS adjustment unit rests
against timing case cover.
Tighten down all bolts.
Remove special tool 11 2 300 .
Caution!
The camshafts remain locked in position with special tool
11 7 120 .
Carefully rotate engine at central screw against direction of
rotation until there is noticeable resistance and spline hubs
are at the stop.
Note:
This procedure creates compensation for play. Only with this
compensation for play is the timing diagram correctly set.
RA Removing and installing left cylinder head (S62)
BMW AG - TIS
21.02.2013 06:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 17 -
