5 Series E39 M5 (S62) SAL
Then crank engine again in direction of rotation until 1st cylinder is
at TDC firing position.
Secure vibration damper in position with special tool 11 2 300 .
Cylinder bank 5 to 8:
Note:
To tighten down screws on VANOS gear: Use special tool
11 7 200 .
Tighten down six accessible screws (three on exhaust side and
three on inlet side) on VANOS gear to 10 Nm.
Cylinder bank 5 to 8:
Remove special tool 11 7 120 .
Remove special tool 11 2 300 . Crank engine at central bolt in
direction of rotation a further revolution up to overlap TDC
position.
RA Removing and installing left cylinder head (S62)
BMW AG - TIS
21.02.2013 06:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 18 -