5 Series E39 M5 (S62) SAL
Cylinder bank 5 to 8:
Note:
To tighten down screws on VANOS gear: Use special tool
11 7 200 .
Tighten down remaining six bolts on VANOS gear to 10 Nm.
Rotate crankshaft in direction of rotation as far as ignition TDC
position of cylinder 1. Secure vibration damper in position with
special tool 11 2 300 .
Note:
Signal rings of inlet and exhaust camshafts are different.
1)
Signal ring of inlet camshaft with one dowel pin
2)
Signal ring of exhaust camshaft with two dowel pins
Fit signal rings, align bores (1 and 2).
Install banjo bolt (1).
Grip camshaft at hexagon head and tighten down banjo bolt (1).
Tightening torque, refer to 11 31 13AZ .
RA Removing and installing left cylinder head (S62)
BMW AG - TIS
21.02.2013 06:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 19 -