5 Series E39 M5 (S62) SAL
Cylinder bank 1 to 4:
Install all bolts. Alternately tighten down bolts in 1/2 turn
increments carefully and evenly until VANOS adjustment unit rests
against timing case cover.
Tighten down all bolts.
Remove special tool 11 2 300 .
Caution!
The camshafts remain locked in position with special tool
11 7 120 .
Carefully rotate engine at central screw against direction of
rotation until there is noticeable resistance and spline hubs
are at the stop.
Note:
This procedure creates compensation for play. Only with this
compensation for play is the timing diagram correctly set.
Then crank engine again in direction of rotation until 1st cylinder is
at TDC firing position.
Secure vibration damper in position with special tool 11 2 300 .
RA Removing and installing right cylinder head (S62)
BMW AG - TIS
21.02.2013 06:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 17 -
