5 Series E39 M5 (S62) SAL
Cylinder bank 5 to 8:
Check camshaft adjustment.
Note:
Groove on 1st bearing cap is a little wider than groove in
camshaft.
Groove of inlet and exhaust camshafts must be inside groove on
1st bearing cap.
If necessary, adjust camshaft timing.
Cylinder bank 5 to 8:
Replace sealing rings.
Fit oil line to VANOS adjustment unit.
Tightening torque, refer to 11 36 9AZ .
Cylinder bank 1 to 4:
Remove special tool 11 7 130 from VANOS adjustment unit.
Replace sealing rings.
Attach oil line to VANOS adjustment unit.
Tightening torque, refer to 11 36 9AZ .
Assemble engine.
Caution!
There is air in the VANOS system once it is opened.
In the first few seconds after startup this results in a clearly
discernible "rattling noise".
This rattling noise does "not" indicate incorrect assembly.
The rattling noise will disappear as soon as the oil pressure
has built up and the system has vented.
RA Removing and installing right cylinder head (S62)
BMW AG - TIS
21.02.2013 06:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 22 -
