bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

11 RA Removing And Installing_replacing Toothed Shafts Of VANOS Gear On Left And Right|Page 896 > < 10 RA Removing And Installing_replacing Toothed Shafts Of VANOS Gear On Right (S62)|Page 894
Page 1
background image

 11 36 090

Removing and installing/replacing toothed
shafts of VANOS gear on left and right (S62)

Special tools required:

11 2 300

11 7 120

11 7 130

11 7 150

11 7 200

12 6 050

12 6 410

12 6 411

Read fault memory and make a documentary record.

Open drain plug on radiator. Unfasten drain plug for coolant on
right engine block. Drain and dispose of coolant.

Installation:

Replace drain plug sealing ring on engine block.

Tightening torque, refer to 11 11 5AZ.

Top up coolant. Vent cooling system and check for leaks.

Remove intake filter housing upper section with air-mass flow
sensor.

Remove intake air manifold.

Remove both cylinder head covers.

Remove all spark plugs.

Remove water hoses between radiator and thermostat housing.

Remove fan clutch with fan impeller and fan cowl.

RA  Removing and installing/replacing toothed shafts of VANOS gear on left and right

BMW AG - TIS

21.02.2013  15:13

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

11 RA Removing And Installing_replacing Toothed Shafts Of VANOS Gear On Left And Right|Page 896 > < 10 RA Removing And Installing_replacing Toothed Shafts Of VANOS Gear On Right (S62)|Page 894