5 Series E39 M5 (S62) SAL
Cylinder bank 5 to 8 (inlet side):
Keep timing chain tensioned and feed on inlet chain wheel (3).
Note:
The position of the bores in the inlet chain wheel (3) can be freely
selected; they do not have to line up with the threads yet.
Position inlet chain wheel (3) on centering sleeve. Do not insert
"any" screws into inlet chain wheel (3) yet.
Note:
If a chain tensioning piston is reused, the oil chamber in the chain
tensioner must be drained.
Install chain tensioning piston.
"No" screws are inserted in inlet sprocket wheel yet. Inlet sprocket
wheel must not slip off centering sleeve.
Rotate crankshaft from 45
°
before TDC position in direction of
rotation up to TDC firing position. Secure vibration damper in
position with special tool 11 2 300 .
Cylinder bank 5 to 8 (inlet side):
Check position of inlet chain wheel (3) to threads.
In event of large deviation (thread not visible):
Detach inlet sprocket wheel (3) from centering sleeve; in so
doing, keep timing chain tensioned, realign inlet sprocket
wheel (3) and refit.
In event of small deviation:
Position special tool 11 7 150 at toothed sleeve on exhaust
side. Align secondary chain drive to bores of inlet chain
wheel (3).
RA Removing and installing/replacing left VANOS gear (S62)
BMW AG - TIS
21.02.2013 15:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 15 -
