5 Series E39 M5 (S62) SAL
Cylinder bank 1 to 4:
Press and hold down toggle switch button 1 on special tool
12 6 050 .
At same time, rotate inlet camshaft at hexagon drive against
direction of rotation as far as it will go.
Note:
Spline teeth in VANOS gear are engaged; and inlet camshaft
cannot be rotated further.
Cylinder bank 1 to 4:
Alternately press toggle switch buttons 3 and 4 several times on
special tool 12 6 050 .
Cylinder bank 1 to 4:
Press and hold down toggle switch button 3 on special tool
12 6 050 .
At same time, rotate exhaust camshaft at hexagon drive against
direction of rotation as far as it will go.
Note:
Spline teeth in VANOS gear are engaged; and exhaust camshaft
cannot be rotated further.
Cylinder bank 1 to 4:
Check camshaft adjustment.
Note:
Groove on 1st bearing cap is a little wider than groove in
camshaft.
Groove of inlet and exhaust camshafts must be inside groove on
1st bearing cap.
RA Removing and installing/replacing left VANOS gear (S62)
BMW AG - TIS
21.02.2013 15:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 24 -