5 Series E39 M5 (S62) SAL
Cylinder bank 5 to 8:
Caution!
Ensure that both VANOS splined shafts remain in initial
position during assembly procedure.
Rotate splined shafts of inlet and exhaust sides until straight
splines are engaged.
Push VANOS adjustment unit with splined shaft into VANOS gear
until helical cut splines (2) are positioned shortly before meshing
with spline hub (1).
Cylinder bank 5 to 8 (exhaust side):
If the helical cut splines cannot be pushed into the spline hub (1):
Place special tool 11 7 150 on bore in spline hub (1). Rotate
spline hub (1) against direction of rotation until splined shaft (2)
is positioned with spline hub (1) exactly "tooth-to-tooth gap".
Caution!
The "first" fitting tooth must snap into place.
Cylinder bank 5 to 8 (inlet side):
Place special tool 11 7 150 on bore in spline hub (1). Rotate
spline hub (1) against direction of rotation until splined shaft (2)
is positioned with spline hub (1) exactly "tooth-to-tooth gap".
Caution!
The "first" fitting tooth must snap into place.
Cylinder bank 5 to 8 (inlet side):
Align radial piston pump to driver on spline hub.
Note:
Picture shows a schematic representation.
RA Removing and installing/replacing toothed shafts of VANOS gear on left and right
BMW AG - TIS
21.02.2013 19:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 16 -
