5 Series E39 M5 (S62) SAL
13 54 ...
Supplementary work for basic throttle setting
(S62)
This work is carried out:
•
on engines with adjustable pull rods at both cylinder banks
•
if the throttle opening of 24.2 mm
±
0.5 mm cannot be
achieved when the full-load adaptation stop is set
The non-adjustable pull rod (1) of cylinder bank 1-4 is replaced
by an adjustable pull rod (2) (versions as on cylinder bank 5-8).
Clip in adjustable pull rod (2) of cylinder bank 1-4 on throttle side
only.
Clip in adjustable pull rod of cylinder bank 5-8 on throttle and
servomotor sides.
Turn back stop screw (1) a few turns.
This ensures that the stop screw does not influence the
servomotor-side stop.
Activate servomotor at specified value 100 % and check
whether measurement (A) = 24.2 mm
±
0.5 mm is achieved.
RA Supplementary work for basic throttle setting (S62)
BMW AG - TIS
21.02.2013 16:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
