5 Series E39 M5 (S62) SAL
Note:
To simplify synchronization, correct height of dial gauges in
such a way that large needles point upwards.
Turn dials on both dial gauges so that large needles point to
zero.
Gently open and close each throttle bank several times to
check if the large needles are always pointing to zero.
If necessary, correct dials.
Clip in both pull rods (1) and (2) on servomotor side.
Note:
Because of the closing force of the return spring in the
servomotor, one or both dial gauge(s) can display a slight
deviation from zero (approx. 0.01 mm). Do not correct dials
on dial gauges.
Activate servomotor at specified value 1 %.
Caution!
Do not open throttles by hand.
Servomotor shaft with twin lever would thus receive a different
radial position. This would result in an incorrect measurement
result and incorrect throttle setting.
RA Supplementary work for basic throttle setting (S62)
BMW AG - TIS
21.02.2013 16:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
