5 Series E39 M5 (S62) SAL
When the servomotor is activated at specified value 1 %,
throttles 3 and 6 are opened to such an extent that the dial
gauges indicate a change between 0.2 mm and 0.4 mm. Check
whether both dial gauges indicate the same value.
If necessary, turn hexagon head on adjustable pull rod 1-4 slightly
until both dial gauges indicate the same opening value for
throttles 3 and 6.
Enter specified value of 0 % and re-enter specified value of 1 %.
Check whether both dial gauges indicate the same opening value
for throttles 3 and 6.
Deviation between both dial gauges must be less than 0.03 mm.
Caution!
As the engine wiring harness is only partially mounted, fault
messages are stored in the DME control unit.
Remove sealing flange for intake air manifold on left (cylinders 5
to 8),
refer to 11 61 056.
Assemble engine.
Note:
Interrogate fault memory of DME control unit.
Check stored fault messages.
Rectify faults.
Now clear the fault memory.
RA Supplementary work for basic throttle setting (S62)
BMW AG - TIS
21.02.2013 16:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
