5 Series E39 M5 (S62) SAL
13 54 030
Removing and installing/replacing throttle
body (S62)
Note:
Interrogate fault memory of DME control unit.
Switch off ignition.
Remove manifold for intake air,
refer to 11 61 050.
Instructions apply to removing and installing both throttle
body assemblies on left and right.
The illustrations show the left throttle body assembly being
removed.
Disconnect plug connections (1).
Unclip cables (2) from cable guides.
Disconnect plug connections (1) on left knock sensor pair.
Disconnect plug connection (1) on throttle actuator.
Unhook cable duct (2) from mounts and raise approx. 2 cm.
Installation:
Check seating of rubber grommet on ignition coil cable.
Unclip cable strip (3) from injector valves, push upwards and tie
back with cable ties (e.g. to engine hood).
RA Removing and installing/replacing throttle body (S62)
BMW AG - TIS
21.02.2013 16:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
