5 Series E39 M5 (S62) SAL
13 62 560
Removing and installing/replacing air-mass
flow sensor (S62)
Note:
The removal and installation of the left air-mass flow sensor
is described in the following text. The same procedure
applies to the removal and installation of the right air-mass
flow sensor.
Interrogate fault memory of DME control unit.
Switch off ignition.
Remove and install intake hose,
refer to 13 54 250.
Disconnect plug connection (1) from air-mass flow sensor.
Open clips (2).
Remove air-mass flow sensor (3).
Installation:
Check O-ring (1) between air-mass flow sensor and intake
filter housing for damage and replace if necessary.
To aid installation, apply a thin coat of petroleum jelly to O-
ring (1).
Interrogate fault memory of DME control unit.
Check stored fault messages.
Rectify faults.
Now clear the fault memory.
RA Removing and installing/replacing air-mass flow sensor (S62)
BMW AG - TIS
21.02.2013 16:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
