5 Series E60 525d (M57TU) SAL
Release screws (1) and nut (2) and remove transmission cross-
member.
Tightening torque 23 71 2AZ/ 5AZ
.
-
Remove propeller shaft from transmission.
-
Release centre bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
•
Unlock and disconnect plug (1) by turning.
•
Release cable from retainers.
•
Insert special tool 24 2 390 in sealing sleeve.
These tasks are described in Notes on mechatronics.
(Important: Observe important note)
Release screw (1).
Disconnect hydraulic lines (2) to transmission fluid cooler.
Installation:
Replace sealing rings.
RA Removing and installing automatic transmission (6HP26Z) M57TU
BMW AG - TIS
11.02.2013 14:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
