5 Series E60 M5 (S85) SAL
13 54 010
Performing throttle valve basic setting (S85)
Important!
Idle stops of throttle valve assemblies must not be altered!
They have been set at the factory and secured against turning
with locking paint.
Necessary preliminary tasks:
•
Read out fault memory of DME control unit.
•
Switch off ignition.
•
Remove intake air manifold.
Important!
The throttle valve assembly must be replaced if the locking
paint is damaged or the idle speed stop screw (1) is twisted!
Plastic caps (2) on idle speed top screws must not be
removed!
Checking throttle valve basic setting:
To ensure that the throttle valve basic setting at the 10th throttle
valve assembly can be properly checked, it is necessary to
remove cover (2).
Unclip lines (1).
Release bolts and remove cover (2).
Tightening torque 13 54 2AZ
.
RA Performing throttle valve basic setting (S85)
BMW AG - TIS
22.02.2013 17:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -