5 Series E60 M5 (S85) SAL
13 54 546
Removing and installing/replacing right Hall
sensor (S85)
Special tools required:
•
34 3 171
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Switch off ignition
•
Follow instructions on connecting and disconnecting battery
•
Disconnect battery negative lead and cover
•
Remove intake air manifold
Note:
Hall sensor and throttle valve assembly 5 are removed together
as a single unit.
Release screws and disconnect injection pipe (1).
Release screw connections (2) of actuating levers. Grip screw
and turn nut in the process.
Remove screws from bores.
Installation:
-
Use screws and nuts only once.
-
Only turn nuts and grip screws.
-
Tightening torque 13 41 3AZ
.
Unclip pull rods (3).
RA Removing and installing/replacing right Hall sensor (S85)
BMW AG - TIS
22.02.2013 17:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
