5 Series E60 M5 (S85) SAL
13 62 560
Removing and installing/replacing air-mass
flow sensor (S85)
Necessary preliminary tasks:
•
Read out fault memory of DME control unit; if necessary,
work through test schedules
•
Switch off ignition
Note:
Illustration shows and description refers to the left air-mass flow
sensor. The procedure is identical for the right air-mass flow
sensor.
Unlock plug (1) and remove.
Unfasten screws.
Pull air-mass flow sensor (2) out of intake filter housing.
Installation:
Check sealing ring between air-mass flow sensor and intake filter
housing for damage, replace if necessary.
Note:
Check stored fault messages.
Now clear the fault memory.
RA Removing and installing/replacing air-mass flow sensor (S85)
BMW AG - TIS
22.02.2013 17:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
