5 Series E60 M5 (S85) SAL
26 12 001
Replacing complete propeller shaft centre
bearing (constant-velocity joint)
Special tools required:
•
00 7 500
•
24 0 090
•
24 1 050
•
33 1 307
Remove propeller shaft.
Important!
Propeller shaft is balanced as a unit.
Mark front propeller shaft relative to rear propeller shaft with paint
stick.
Marking by means of engraving which causes surface
damage (e.g. centre mark) is not permitted.
Release screw (1).
Pull propeller shaft apart.
Installation:
Thread free from grease.
When pushing shaft together, make sure that markings match up.
Insert bolt (1) with thread-locking liquid,
refer to BMW Parts Service.
Tightening torque 26 11 5AZ
.
RA Replacing complete propeller shaft centre bearing (constant-velocity joint)
BMW AG - TIS
22.02.2013 19:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
