5 Series E60 M5 (S85) SAL
34 52 535
Replacing a rear pulse generator
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Remove rear wheel.
•
Read and comply with General Information.
Observe safety instructions on raising the vehicle.
Open plug housing (1).
Pull plug connection (2) out of mounting and disconnect.
Pull cable out of brackets on swinging arm.
Installation:
Ensure proper locking of the plug connector and proper seating of
the cable in the brackets.
Release hexagon socket head cap screw (1) and pull wheel
speed sensor out of bore.
Installation:
Tightening torque 34 51 6AZ
.
Clean bore hole for pulse generator and grease with
Staburags NBU 12/K lubricating grease (refer to BMW
Service Operating Fluids).
RA Replacing a rear pulse generator
BMW AG - TIS
22.02.2013 21:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
