7 Series E38 728i (M52TU) SAL
4
Bracket for front grab handle
5
Bracket on B-pillar
6
Bracket on B-pillar
7
Bracket, grab handle, rear
8
Mounting bolt on C-pillar
Note:
The bracket for the filler hose of the ITS head airbag is not shown in this illustration.
In the L7, an additional steel bracket is fitted in front of the C-pillar retaining screw.
Cut open cable tie (1).
Disconnect plug connection (2) for gas generator, ITS head
airbag,
refer also to 72 12 ... Unlocking/locking airbag plug connections.
Unfasten self-locking nut (1).
Remove gas generator of ITS head airbag (2).
Installation:
Replace self-locking nut.
Tightening Torque,
refer to Technical Data 72 12 2AZ
Installation:
Lug (1) of gas generator of ITS head airbag must be secured
in hole (2) of A-pillar!
RA Removing and installing / replacing left or right ITS head airbag (model without
BMW AG - TIS
26.01.2013 21:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -