7 Series E38 740iL (M62) SAL
Put the cylinder head on. Install new cylinder head bolts. Do not
wash off bolt coating.
Note:
Use special tool 00 9 120 for torsion angle tightening.
Tighten down cylinder head bolts in sequence 1 to 10.
Tightening torque, refer to Technical Data 11 12 8AZ.
Caution!
Do not damage the cylinder head.
Rotate camshafts until camshaft markings face upwards.
Fit special tool 11 2 445 / 441 to camshafts on cylinder
bank 1 to 4.
RA Removing and installing right cylinder head (M62 VANOS from 9/98)
BMW AG - TIS
17.02.2013 15:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
