7 Series E38 L7 (M73) SAL
Snap out hook (1) and detach plastic cover (2) from cup holder
front section (3).
Installation:
Snap plastic cover (2) into correct position.
Release nuts (1) with toothed washers
and remove wooden finisher (2) from cup holder front
section (3).
Installation:
Fit and screw down wooden finisher (note installation
position).
Tightening Torque,
refer to Technical Data 51 16 7AZ.
Carry out function check of gap.
Installation:
Threads (1) of wooden finisher (2) must not be damaged.
RA Removing and installing/replacing wooden finisher and front section on cup holde
BMW AG - TIS
22.02.2013 05:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
