7 Series E38 L7 (M73) SAL
Take new trim assembly,
insert guide in center rail,
raise rear cover (1) slightly
and snap front section (2) with center section (3) into place.
Center section (3) must be held in the process.
Note:
If necessary, use a hand mirror (1) for better visibility.
Insert rack (2) into bore in front section (3) and hook in towards
left.
Carry out function check and note gap of cup holder.
Replacing wooden finisher for cup holder:
Remove cover for cup holder (with wooden finisher).
Press together legs on both setting levers (1) and snap out.
Caution!
Do not lose spring (2).
Installation:
Insert one leg of spring (2) in opening (3) in plastic
cover (4).
RA Removing and installing/replacing wooden finisher and front section on cup holde
BMW AG - TIS
22.02.2013 05:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
