7 Series E66 730Li (N52) SAL
Sealing connections on hydraulic unit and hose connections for
hydraulic cylinders:
Hydraulic unit:
Use seal plugs from "Small parts for hydraulic unit"* set and
removed seals.
Hose connections:
Use seal plugs with cap nuts from "Small parts for hydraulic unit"*
set and removed seals.
* Sourcing reference: BMW Parts Service
Installation:
Always fit new banjo bolts (1) and seals (2 and 4).
1
Hollow screw
2
Upper seal (thin)
3
Hose connection
4
Lower seal (thick)
•
Check fluid level in hydraulic unit
Replacement only:
If necessary, replace faulty mounts (1) for hydraulic unit (2).
RA Removing and installing/replacing hydraulic unit for rear lid actuation (electro
BMW AG - TIS
07.02.2013 18:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -