7 Series E66 745Li (N62) SAL
Installation:
Check fluid level in automatic
transmission; top up if necessary.
Unclip cable duct of oxygen sensors from automatic transmission.
Release screw, remove tensioner (1) from A/C compressor drive
belt (E65 only).
Unfasten screws.
Release screws and remove oil sump top section.
Installation:
Replace sealing ring on dipstick guide tube.
Free sealing faces of seal debris and clean.
1.
Replace gasket.
2.
Install oil sump.
3.
Insert all screws on transmission end,
4.
Tighten down all screws on oil sump.
Tightening torque 11 13 2AZ
.
RA Removing and installing/replacing oil sump top section (N62/N62TU)
BMW AG - TIS
11.02.2013 06:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -