X Series E53 X5 3.0i (M54) OFFRD
Release screws.
Tightening torque, 23 00 1AZ.
Pull out transmission towards rear as far as possible, turn approx.
10
°
counterclockwise and remove.
Installation:
Pay attention to adapter sleeves (1 ... 2), replace if necessary.
Ensure correct position of cover plate.
Installation:
Remove release unit and release lever, clean and apply
grease to relevant points.
Installation:
Check lubrication of transmission input shaft for sticky
consistency. If grease is sticky, replace clutch plate.
Check clutch plate for friction rust in taper splines and replace
if necessary.
Mechanically remove old grease and lining abrasion from the
taper splines of the clutch disk (with a cloth).
Then apply a thin and even coat of grease with a brush in
entire area of taper splines. Also in taper groove and on guide
pin.
RA Removing and installing transmission (S5D 280Z, M54)
BMW AG - TIS
06.02.2013 18:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
