X Series E53 X5 4.8is (N62-S) OFFRD
Note:
Removal of the intermediate levers and torsion springs is
described on the 8th cylinder. The same procedure is applicable
to cylinders 5 to 7.
Raise one end of torsion spring (1) with special tool
11 9 480 .
Lift out intermediate lever (2) and set down in an orderly fashion.
Important!
Keep holding torsion spring (1) with special tool 11 9 480 .
Attach special tool 11 9490 to end of torsion spring.
Support end of torsion spring protected with special tool 11 9490
on inlet camshaft.
Important!
Intermediate levers (2) are divided into individual tolerance
classes.
Only intermediate levers of the same tolerance class may be
fitted in a single cylinder head.
The tolerance classes are designated as illustrated with the
numbers from 1 to 5.
Used intermediate levers (2) may only be reused in the same
position.
Raise second end of torsion spring (1) with special tool
11 9 480 .
Lift out intermediate lever (2) and set down in an orderly fashion.
Important!
Keep holding torsion spring (1) with special tool 11 9 480 .
RA Removing and installing/replacing left inlet camshaft (N62 from 9/03 and N62TU)
BMW AG - TIS
12.02.2013 04:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -