X Series E70 X5 3.0Sd (M57T2) OFFRD
Release hollow nuts of control lines (1, 2) to front axle oscillating
motor with special tool 37 1 151 .
Release hollow nuts of control lines (3, 4) to rear axle oscillating
motor with special tool 37 1 151 .
Release hollow nut of pressure line (5) with special tool
13 5 020 .
Release hollow nut of return line (6) with special tool 37 1 152 .
Unclip wiring harness (1).
Release nuts (2) and remove valve block.
Installing valve block:
Replace self-locking nuts.
Mount valve block with nuts (2) on body.
Tightening torque 37 14 10AZ
.
Secure wiring harness (1) to valve block holder.
Important!
When assembling, make sure that only the sealing plugs of
the line to be fitted are removed.
Do not damage sealing surfaces of hydraulic lines.
Note:
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
RA Removing and installing/replacing DYNAMIC DRIVE valve block
BMW AG - TIS
05.02.2013 10:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -