Removing and Installing Dynamic Drive Valve Block | X5 30Sd (M57T2) Offrd Repair
Installation sequence for hydraulic lines:
1.
Install control lines (3, 4)
Tightening torque 37 14 14AZ
.
2.
Install pressure line (5)
Tightening torque 37 14 11AZ
.
3.
Install return line (6)
Tightening torque 37 14 12AZ
.
4.
Install control lines (1, 2)
Tightening torque 37 14 13AZ
.
Check seating and position of line holder (1), correct if
necessary.
Replace screw pins (1).
Insert hydraulic lines in holder and seal holder with screw
pins (1).
Tightening torque 37 14 22AZ
.
Insert control lines in holder (1) and seal holder.
Note:
Replace damaged holder.
RA Removing and installing/replacing DYNAMIC DRIVE valve block
BMW AG - TIS
05.02.2013 10:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -