X Series E70 X5 3.0Sd (M57T2) OFFRD
41 34 038
Replacing outer tail panel section
Read contents of Body, General.
For stripping and rigging operations, refer to texts on KSD
CD (FR number 41 34 038).
Remove or cover those vehicle components in the repair area
which are susceptible to heat or dust.
Spot-weld bonding is used on this vehicle. Observe specific
procedure.
Use only approved spot-welding apparatus for repairs!
Following new body parts are required (refer to Electronic Parts
Catalogue ETK):
-
(1) Rear trim
Open weld joints (1).
Open brazed joints (2).
Carry over the work step shown symmetrically to the other side of
the vehicle.
Open weld joints in areas (1).
Open adhesive bonds in areas (2).
Remove rear trim.
Installation:
Replace glued connection in areas (2) with plug welding.
Adjust rear lid lower section to fit before welding.
RA Replacing outer tail panel section
BMW AG - TIS
05.02.2013 10:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -