X Series E70 X5 3.0Si (N52K) OFFRD
Important!
Cut outer plate only for following severance cuts.
Measurement a = approx. 200 mm behind hole dia. 25 mm.
Measurement b = approx. 150 mm from roof edge.
Measurement c = approx. 80 mm below cut b.
Measurement d = approx. 200 mm from centrepoint of hole dia. 25 mm.
Open weld joints in areas (1) and (2).
Open adhesive bonds in areas (3).
Installation:
Cut out metal section (4) is needed again for sealing.
Weld in reinforcing panels at all severance cuts.
Bond and rivet new part in area (2).
Use Hemlock 813 blind rivet (sourcing reference: BMW Parts Service picture board - Aluminium and
steel/bonding and welding).
Double number of rivets with respect to welding spots in area (2).
Mark severance cut in accordance with specified measurement
and cut.
Important!
Cut outer metal plate only for following severance cut.
Measurement a = 190 mm from roof edge.
Installation:
Weld in reinforcement plate at severance cut.
Note:
View from inside
Open weld joints in area (1).
RA Replacing cover for longitudinal member with left door pillar (partial replaceme
BMW AG - TIS
06.02.2013 21:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
